17
Dimensions in parentheses are in
millimeters unless otherwise specified.
I N S TA L L AT I O N
I N S T R U C T I O N S
Hinge
Retainer
Plate
Upper Mounting
Screw
Hinge
Pin
Kickplate
Oven door reinstallation
IMPORTANT NOTE: Fully extend the hinge
claw which is opposite the hinge pin location
and insert into the hinge pocket prior to
inserting opposite side. This will ease the
installation of the oven door.
OV E N D O O R
R E I N S T A L L A T I O N
IMPORTANT NOTE: The oven door(s) should
not be removed unless it is necessary to fit the
range through a tight doorway. Door removal
should only be done by a qualified service
technician or installer. Door removal and rein-
stallation may cause damage to the porcelain
interior of the oven or door(s).
If the oven door(s) have been removed as
described on page 12, follow these steps to
reinstall:
1)
Hold the oven door on both sides and
position it with door hinges aligned with
openings in the oven frame.
2)
Holding the oven door at an approximate
30° angle from vertical, slide the hinges into
the openings until the bottom hinge arms
drop fully into the hinge receptacles.
3)
Open the oven door to its fully opened
position. Remove the hinge pin from the
appropriate hinge arm. Refer to the
illustration below.
4)
Reinstall the hinge retainer plate with upper
and lower mounting screws.
5)
Open and close the door completely to
ensure that it is properly installed.
6)
For 48" (1219) and 60" (1524) gas ranges,
complete these steps for both oven doors.
Do not lift or carry the oven door by the
door handle.
