Sealed Burner Rangetop Installation
14
Verify Rangetop Operation
IMPORTANT NOTE:
Prior to operating the rangetop, be
sure to read the entire Wolf sealed burner rangetops use &
care guide included with the rangetop for important safety,
service and warranty information.
SURFACE BURNERS
Turn on the power supply to the rangetop. Place the
burner cap on each burner base and position the burner
grates before lighting.
Surface burners of the sealed burner rangetop use elec-
tronic igniters. When the control knob is pushed in and
turned to the HIGH position, the system creates a spark
to light the burner. This sparking continues until the elec-
tronic ignition senses a flame.
To check operation of the surface burners, push in and
turn each control knob to the HIGH position. The flame
should light within four seconds.
If the burners do not light properly, turn control knobs to
the OFF position. Check that burner caps are in the proper
position. Make sure electricity is being supplied to the
rangetop and that the gas shut-off valve is in the open
position. Check operation again. If the burners still do not
light properly, contact Wolf factory certified service.
IMPORTANT NOTE:
Initial lighting of the surface burners
may take slightly longer, as air in the system must be
purged before gas can be supplied to the burner.
Rangetop Removal
If removal of the sealed burner rangetop is necessary for
cleaning or service, shut off the gas supply. Unplug the
rangetop and disconnect the gas supply line. Remove the
rangetop. Reinstall in the reverse order and be sure to
check gas connections for leaks.
Refer to the Wolf sealed burner rangetops use & care
guide for cleaning recommendations.
Unplug the rangetop and disconnect the gas supply
line before removing.
