21
Dimensions in parentheses are in
millimeters unless otherwise specified.
I N S TA L L AT I O N
I N S T R U C T I O N S
A C C E S S O R I E S
Optional acces-
sories are available
through your
Wolf dealer. To
obtain local dealer
information, visit
the Locator section
of our website,
wolfappliance.com.
I N S T A L L
F I LT E R S / G R E A S E C U P S
Remove all packaging material from the
filters and grease cups.
Slide the grease cups along the bottom
edge of the hood so that the lip of the
grease cup overhangs slightly.
Install the filters. Orient each filter with
lines running vertically. Position the top
edge of the filter as shown in the illustra-
tion below. While pressing up against the
spring, rotate the bottom edge of the filter
into position next to the grease cup. Gloves
should be worn to provide proper grip.
D U C T C OV E R
I N S T A L L A T I O N
Optional
Duct Cover
Mounting
Screws
Duct cover installation
Installing a duct cover assembly will
impact all aspects of the hood installa-
tion including hood location, ducting,
electrical placement and the mounting
surface.
IMPORTANT NOTE:
If a duct cover is to be
used, follow these instructions before
installing the wall hood.
Attach the duct cover from the inside of the
hood through the filter opening using the
screws provided.
Leave screws partially loose until all screws
are installed. Check alignment of the duct
cover with the hood and tighten the four
corner screws to secure the duct cover.
Tighten all remaining screws.
For low-profile and 24" (610) wall hoods
follow hood installation instructions on
page 8. For 27" (686) wall hoods follow
hood installation instructions on page 13.
Duct covers 6" (152) and 12" (305) high in
widths to match all wall hoods are available
through your Wolf dealer. To obtain local
dealer information, visit the Locator section of
our website, wolfappliance.com.
Grease Cup
SIDE VIEW
Filter
Spring
Filter and grease cup installation
