48
3062878_201707
10.2.18 Other...
Other...
DISPLAY
SELECTION
Esc BACK
New password
1234
S-01
10. Operating level 2
Standard mask
Esc
Main menu
Heating contractor
Other...
User settings and interfaces can be adjusted and additional sensors can be
configured later.
Password
The password for the heating contractor level can be matched to individual
customer requirements.
BMK key lock
If this parameter is set to "Yes", the key lock is enabled after 2 minutes
without any intervention.
Pressing and holding down the
Esc
Esc
button (for approx. 3 seconds) cancels
the key lock temporarily.
To disable the key lock permanently, set this parameter to "NO".
BMK-F key lock
Individual keys can be locked to restrict the function range of the remote
control unit.
Optional entry of Wolf order number
The order number of the unit can optionally be entered. This allows
additional information to be called up if the unit is connected to the portal.
The order number can be found on the type plate of the relevant unit.
Post-configuration
It is possible to retrofit a remote control, touch panel, air quality sensor,
supply air pressure sensor, process air pressure sensor, room temperature
sensor, extract air temperature sensor, external OFF contact and a
hygrostat, if required.
Please note
Fundamental function extensions, such as cooling function or pressure
regulation, for example, require a reconfiguration of the control unit.
Save / load parameter set
Customer-specific parameter settings can be saved
(e.g. the condition of the system when commissioned)
and reloaded
when required.
It is also possible to restore the factory settings.
Please note
It is not possible to load settings if the control unit has been reconfigured,
because the internal data memory is cleared during reconfiguration.
