Basic Rules for Safety
USE
The infraNOMIC Heating Panels are designed only for use as heaters and are suitable for installation on Walls
or Ceilings in domestic or commercial rooms which are suitable for their installation. To use these heaters
correctly it is necessary to follow the guidelines and instructions laid down in this document.
DO NOT use the heaters in rooms that are open to the elements and/or rooms which could be subjected to the
ingress of running water.
Danger for Children and Persons with disabilities
- These products are not to be installed by people (including children) who are physically or mentally
handicapped, unless a competent person who can provide help and instruction is present.
-
Be sure that children do not play with or use the heaters as a toy.
-
Make sure that the packing material is kept away from babies and small children as suffocation can result if
placed over their mouths or noses.
Electrical Safety
-
Connect and run the heater according to the advice given on the specification plate on the rear of the heater.
Only connect the heater to a 230 / 240 V AC supply grid.
-
Check each heater for damage before installation. Make sure that the heater itself; its plug and cable are free
of any visible signs of damage.
-
ATTENTION: The Heating Panels should
not
be used, if the Glass or Ceramic backing is damaged. If
damage is noticed, immediately disconnect the Panel from the Power supply and contact our Service
department.
-
Do not pull, clamp or in any other way damage the connecting cable attached to the Panel.
-
If the attached connecting cable does appear to be damaged please refer to the manufacturer or his service
department or a similarly qualified person to undertake any repair work.
-
Do
not
attempt to carry out any repairs, changes or modifications to the Heating Panel.
-
Before any assembly or cleaning work is carried out, disconnect the Panel from the electrical power.
-
Do
not
immerse the Heating Panel in water or splash water onto it!
-
When installing the Panel in any form of wet room, it and its cabling should be situated well out of reach of
any person using the shower or bath. Do
not
install the Panel in close proximity of a bath, shower or
swimming pool.
-
The installation of these panels in wet rooms should always be carried out by competent electricians who are
completely aware of the specifications for installing electrical equipment in these types of room according to
their own countries laws and standards.
Product Safety Notes
-
ATTENTION: To insure that the Heating Panel does not overheat, it should not be covered in any way.
-
The Panel should not be installed directly under a plug socket.
-
Do
not
rest anything against, or use the Heating panel to dry clothes and/or stick anything onto its surface.
-
Make sure that all local objects in the immediate vicinity of the heater are a minimum of 50 cm away from the
front and sides of the panel and 10 cm away when objects are above.
-
Make sure when installing the Panel that the minimum distance of 2 cm between the Wall or Ceiling and the
Panel is adhered too. This distance insures that enough space is available for air circulation.
2
