Installation
ATTENTION
Please read the section regarding ‘Basic Rules for Safety’ and details involving the Installation location; the
information regarding safe distances and the Operation of the Panel.
Please take note of the following additional information with regards to installation.
-
The minimum dimension from the back side of the panel to the wall or ceiling must be 2 cm. This will
always be the case if the items contained in the accessories are used. If other types of fitting systems are
used our guarantee becomes null and void.
-
The hot side of the heater is always the side with the sticker that says (infraNOMIC Infrarot-Heizelement
Nicht abdecken!) This sticker should always be visible after installation.
-
Check before drilling holes that there are no electrical lines or water pipes hidden in the wall.
-
Make sure that the power supply socket that you intend to use is within distance of the location of where
you intend to install the Panel – The cable attached to the panel is 1.7 m long.
-
With difficult walls it may be necessary to use special rawl plugs.
-
When the ‘Hooked Mounting Screws’ are screwed into the wall it is important that they are screwed in
right up to the flange.
Wall Installation
The Hanging Plates (B) should be attached to
the shorter side of the heating Panel for vertical
Installation and on the longer side for a
horizontal installation. The plates are attached
by using the Bolts (C) – 2 bolts per plate.
make sure that the corner of the panel
where the cable is attached is
not
used for
mounting the plates.
and that the slots in each of the plates are
mounted in the same direction (see picture)
and that the bolts (C) are only hand tight so
insuring no damage to the frame.
Screw the two bolts (D) into the integrated nuts
found in the opposite side of the frame from where
the plates are attached. These bolts insure the
correct distance from wall to the back of the panel
is adhered too.
Measure the distance (X) between the slots and
transfer this measurement to the wall where the
panel is to be installed. Use a Spirit Level to
insure that the marks for drilling are level.
Drill each of the holes with an 8 mm drill to a
depth of minimum 60 mm.
4