Fixing the Visualizer onto the table
The Visualizer can be fixed with a
, so that it
can not be stolen
. Follow the
instructions from the cable lock manual.
security cable T-bar lock
T-bar lock
®
(Kensington Lock)
slot for lock
12
Anti-theft
Technical Specifications are Subject to Change!
The Visualizer can also be fixed onto a table with the supplied table mounting set in order to minimize the
risk of theft. Maximum thickness of the table is 35mm [1.38"] and a free area of at least 620mm x 350mm
[24.4" x 18.8"] would be required. Drill a whole into the table on the desired position: Ø 42mm [1.65"].
1. Fold the unit to remove the cover.
2. Remove the original base plate by removing both screws (keep it for further use).
3. Place one adapter plate and both screws (M4x50 Torx20) and fix it with at least one nut. Place the
necessary cables and connect it (begin with the biggest connector; depending on installation,
place the cables first through the second adapter plate and the table-drilling).
4. Mount the cable shield (if desired) with the supplied screws (K22x8 countersunk Torx6).
5. Place the unit onto the table, the screws through the drilling and mount the second adapter plate
with washers and hex nuts.
6. Fold the unit to slide in the cover.
