Mount the Visualizer onto swivel using both screws M4x8 (Torx 20) and both washers.
To access the screw holes, the back cover has to be removed first
.
Mount the Visualizer onto Swivel Plate
14
Optional: Mounting
(
)
Cable Shield cables guided through table top
When the cables are guided through the table top, the cable shield can be mounted. Just fold the unit,
remove the cable cover (all desired cables has to be connected). Mount the shield with the two supplied
screws K22x10 (Torx6). Place the cover by sliding in. The Visualizer may have to be rotated to access the
screw holes from underneath.
Optional: Place Working Surface Foil
Connect the Visualizer to a display device and power supply. Lift the arm to working position to switch it on.
Clean the table to ensure adhesive fastening.
Zoom to full Wide end position by using the zoom wheel and check position of pick-up area on the display
device to place the optional working surface foil.
Peel off the protection foil from backside of the optional working surface foil, attach it onto the table at the
previously evaluated position (start at one edge and smooth it down to the other edge to prevent air
bubbles).
Connect all desired cables and
fix it with the cable tie.
To place the cover, fold the unit and slide it in.
Cables can be guided through table top by using the cable guide holes of the swivel
or to the back above table top.
