A very useful method to calculate the exact positioning and the possible image sizes is a dedicated
calculation program on WolfVision's homepage:
Calculation program on WolfVision Homepage
5
If the Visualizer needs to be suspended further from the ceiling than with the supplied ceiling mount (in
order to allow greater magnification), a standard ceiling mount or ceiling lift for projectors may be used.
An adapter plate, suitable for weight and screw fittings for the Visualizer, might be necessary.
Fixing the assembly to the ceiling is dependent on the respective construction and desired mounting
location.
Ensure that the ceiling construction is able to carry a weight of 26kg (58lbs) and that possible
collision accidents are prevented.
Important: Please give special attention to the country specific regulations for training and
conferencing rooms!
G
IMPORTANT: Ensure solid mounting and secure connection of all parts to avoid the
possibility that the unit detaches itself from the ceiling.
Installation of an Additional Ceiling Mount (third-party)
When the unit is built-in into the ceiling or into a plenum box, the infrared receiver may be covered. If the
internal infrared receiver is insufficient, the supplied external infrared receiver should be connected to the
"IR-SENSOR" port.
Alternatively, the unit can be controlled via LAN.
The Ceiling Visualizer is plenum rated and a plenum box is not necessary. However when the Ceiling
Visualizer will be installed in a Plenum box keep enough clearance around to enable mechanical fine-
adjustment of the Visualizer by moving and rotating.
Installation in a Suspended Ceiling or Plenum Box
www.wolfvision.com
(Support)
