To show 3-dimensional objects with the WolfVision Visualizer, just place them on the working surface and
adjust ZOOM and
FOCUS. Due to a special WolfVision lens the object can be up to 25 cm (9.7") in height. If
the object is too big for the working surface or if you want to show it from the side, just place it behind or in
front of the unit and tilt the top mirror by hand or by using the MIRROR slider
.
In this way it is also possible to make recordings of objects in the room or surrounding area, just like with a
video camera.
Due to the Visualizer's great focal range it is possible to show details from any distance to the unit.
If you want to record people you should turn off the light with the LIGHT icon
,
so that they are not blinded by
the light.
Shooting Area Outside of the Working Surface
1. Place your subject material on the working surface. The
synchronized lightfield
on the working
surface marks the pick-up area of the built-in camera. Just place your subject material in the illuminated
area.
2. Select the enlargement required with the ZOOM slider (wheel).
3. Use the MIRROR slider to change the vertical position of the pick-up area. The sensing head (top
mirror) can also be moved by hand. This does not cause any harm to the mirror‘s motor.
Do not touch the mirror surface, as fingerprints cause bright and hazy spots on the picture! Always keep the
mirror clean!
-
see page 21
CAUTION: SENSITIVE FRONT COATED MIRROR!
Shooting Area on the working surface
Eliminating reflections
In order to eliminate reflections (on high gloss photographs etc.) just move the document and rotate the
sensing head to the center of the desired pick-up area.
Please note that reflections can also be caused by general room lighting conditions.
12
to infinity
Tilt range:
105° (30° to s 75° to audience)
