Precautions
ENGLISH
Please observe the following:
Risk of electric shock
Dangerous voltage inside
WARNING!
USE THIS VISUALIZER ONLY WITH THE CORRECT VOLTAGE AS SHOWN ON THE TYPE
LABEL !
DO NOT EXPOSE THE UNIT TO HEAT OR MOISTURE !
DO NOT CARRY THE VISUALIZER HOLDING IT ONLY BY IST MIRROR ARM !
DO NOT PUSH OR PULL THE ARM MANUALLY!
PROTECT THE UNIT FROM EXCESSIVE SHOCKS !
Make sure that sufficient air circulation for cooling the unit is possible (ventilation slots on
the underneath of the unit)!
If there is any abnormality (abnormal noise, smell, smoke etc.) disconnect the unit from
mains immediately and contact your Visualizer dealer!
Do not use a damaged power cord. This may cause short circuits or electrical shocks!
To prevent danger, do not modify the Visualizer or operate without the cover panel firmly in
place!
Do not expose the Visualizer to water, metallic objects or any flammable material.
Avoid installing the Visualizer in locations exposed to strong magnetic fields or electrical
currents.
Avoid installing the Visualizer in environments where there is radiation. This could cause
monitor image distortion or damage to the CCD camera.
Do not pull the plug from the power socket with wet hands!
If the Visualizer is not used for a long time, disconnect it from mains!
!
Remote control battery: Do not incinerate, disassemble, short terminals, expose to high
temperatures (above 140°F / 60°C)
1
Precautions for laser pointer:
Laser light - Do not stare into beam!
Do not modify the laser! Do not view the laser beam with optical instruments!
Information for laser pointer
FDA accession number: 9912688-00
This device complies with 21 CFR 1040.10 and 1040.11
The laser beam exits the
remote control through the
smaller (left) opening on
the front.
Technical data:
λ
= 635 - 680nm
P < 1mW
Θ
2mrad
This label will be found on the
underneath of the remote
control.
