background image

• Do not look directly at the lighted bulb or point the light directly

at a person's eyes, because the bright light could damage sen-
sitive eyes.

• If your skin feels warm, you are too close to the light fixture.
• This light fixture gets hot.  Always keep light 24 inches away

from combustible materials such as paper cardboard, cloth,
rags and etc. to prevent fire.

• Never operate this light fixture if the safety glass is damaged or

missing.

• Never operate this light fixture if the metal safety grill is not in

place.

• Never touch the light fixture while standing in water.
• Never touch the light fixture while standing on wet or damp sur-

faces.

• Never use this light fixture around swimming pool or hot tubs.
• To reduce the risk of electrical shock, always plug this light into

properly grounded three (3) wired outlet.  

• Never remove the ground wire or three (3) prong ground plug

from the light fixture.

• Always use a U.L. listed three (3) wire grounded power cord

with a wire gauge capable of handling the current load.

• When the bulb in this light fixture requires changing, always

wear safety glasses, remove plug from power source and allow
enough time for light fixture and bulb to cool.

• Before plugging the light into a power source, always make

sure the safety glass front cover is secured to the light fixtures
housing. 

• Never use any bulb other then 

J118 110-130 volt

150 watt

type.  If the wrong bulb is used the light fixture could get too
hot and fire could occur. 

WARNING:

Failure to observe the above safety instructions

could result in electric shock, personal injury and other hazards.

2

Summary of Contents for ILLUME 1 5150









Reviews: