BULB INSTALLATION
The life of the bulb will vary due to voltage surges and the han-
dling of the light fixture. Therefore, the bulb is not covered by any
factory warranty. For maximum life of the bulb, it is recommend
that the light fixture be kept in a horizontal position. Never use
any bulb other then
J118 110-130 volt 150 watt
type. If the
wrong bulb is used the light fixture could get too hot and fire
could occur.
1. If the light fixture
was in use and the
bulb burns out,
allow enough time
so that light fixture
cools before you
attempt to change
bulb.
2.
IMPORTANT:
Always unplug the
light fixture from
the outlet or power
source before
attempting to
change the bulb.
This will protect
the person chang-
ing the bulb from
potential life threatening electrical shock.
3. Always wear safety glasses when replacing the bulb.
4. Remove the wing nut that secures the hook and rubber coat-
ed handle to the light. See fig. A.
5. Remove hook and rubber coated handle.
6. Remove the screw that secures the lens cover to the light’s
housing. See fig. B
3
Screw
