Wolturnus Active Wheelchair Manual 2019
Adjustment and set-up
6.14 Adjustment of tip protection
The anti-tip system prevents the wheelchair from tipping backwards. When making adjust
-
ments that may affect the balance point and weight distribution of the wheelchair, make sure
that the anti-tip system is active. The anti-tip system can be adjusted in length and has two
options for adjusting the angle. Adjustment of the system must always be done, when the
wheelchair is on a flat and horizontal surface.
With the default setting of the anti-tip system, measure vertically from the surface of which
the chair is placed and up to the underside of the anti-tip wheel (Fig. 36). This target must be
60 mm by default.
To achieve the desired position of the anti-tip, one or more of the following settings can be
made:
Adjusting the length:
•
Loosen and remove the bolt and disc with a 4 mm Allen key (Fig. 37).
•
Select one of the two length positions (Fig. 38).
•
Place two drops of Loctite on the bolt thread.
•
Insert the bolt and tighten it.
Fig. 37 Remove bolts
Fig. 38 Choose position
Fig. 36 measuring from floor to anti-tip
A-Run
27
Summary of Contents for Dalton
Page 2: ......
Page 49: ...Wolturnus Active Wheelchair Manual 2019 A Run 49 ...
