Quick Installation Guide
Industrial DIN Rail PoE Switch
DP310
Industrial DIN Rail Ethernet Switch
DS310
Wiring the Relay Output
The relay output of the 2-pin
terminal block connector are used
to detect user-configured events.
The two wires attached to the fault
contacts form a close circuit when a
user-configured event is triggered.
If a user-configured event does not
occur, the fault circuit remains
opened.
Wiring the Power Input
1) Insert the positive and negative
wires into the V+ and V- contact on
the terminal block connector.
2) Tighten screws when the
wire is connected.
3) Connect the power
wires to suitable DC Switching type
power supply.
DP310 and DS310 are industrial 10-port L2 Managed PoE switches
equipped with 8-port Fast Ethernet, both switches provide additional 2-
port RJ45/SFP combo Gigabit Ethernet uplink, prioritized stream such as
video and VoIP are also optimized. High speed uplink connection to
higher level backbone switches with Ring network redundancy technology
ensures the reliability of high-quality video transfer. For the best traffic
control, management side features LACP, VLAN, QinQ, IGMP snooping,
QoS, etc. DP310 is an IEEE 802.3af/at compliant PoE switch for enabling
devices when power sources are not available. All of the 8 ports can
deliver up to 30W power per port to the high-power requiring devices.
・
Overview
•
1 x Product Unit (Without SFP transceiver)
•
1 x 8-pin Removable Terminal Connector
•
1 x Din Clip
•
1 x Quick Installation Guide
Optional Accessory (for detailed information please refer to the
Datasheet)
:
•
100Mbps SFP Transceiver
•
1000Mbps SFP Transceiver
•
RS232 Console Cable
・
Package Checklist
・
Appearance
www.womaster.eu
DP310
DS310
10/100Base-TX
8
8
100/1000Base-T
2, Combo
2, Combo
PoE Standard
IEEE 802.3af/at
-
Power input
46~57VDC
(50~57VDC for
802.3at)
18~60VDC
DIN Rail mount
To mount the switch on the DIN
Rail track, insert the upper end
of the DIN
‐
Rail clip into the
back of the DIN
‐
Rail track from
its upper side and lightly push
the bottom of the DIN
‐
Rail clip
into the track. The DIN Rail
should comply with DIN
EN50022 standard. Using
wrong DIN rail may cause
unsafe installation.
・
Installation
Wiring the Digital Input
To wire the DI on the Terminal
block, loosen screws by screw
driver on the terminal block
connector, insert the positive and
negative wires into the V+ and V-
contact and then tighten screws
after the DI wire is connected.
USB Port
Use the USB port in order to save
or restore the configuration and
upload the firmware upgrade file.
For further configurations, please
refer to User Manual.
Grounding Screw
For avoiding system damage by
noise or electric shock, establish a
direct connection between the
ground screw and the grounding
surface prior to connecting devices.
Grounding Screw
