13
2.5
CONNECTING THE GROUDING SCREW
Grounding screw is located on the front side of the switch. Grounding Screw helps limit the effects of noise due to
electromagnetic interference (EMI) such as lighting or surge protection. Run the ground connection from the ground
screw to the grounding surface prior to connecting devices. And tighten and wire to chassis grounding for better
durability.
2.6 DIN RAIL MOUNTING
The EN50022 DIN-Rail plate should already attached at the back panel of the switch screwed tightly. If you need to
reattach the DIN-Rail attachment plate to the switch, make sure the plate is situated towards the top, as shown by the
following figures.
To mount the switch on DIN Rail track, do the following instruction:
1.
Insert the top side of DIN Rail track into the slot of DIN Rail clip.
2.
Lightly clip the bottom of DIN-Rail to the track and make sure it attached well.
3.
To remove the switch from the track, reverse the steps.
