Take the cover off first and put on the air filter before running the air compressor.
Never unscrew any connecting parts when the tank is in pressure conditions.
Never touch or disassemble any electrical parts before disconnecting the power plug.
Never adjust the safety valve carelessly.
Never use the compressor in place where voltage is too low or too high.
Never use an electrical wire that is more than 5m long with less than the section shown
in Table 1.
If the release valve doesn’t work as the motor has stopped, find the cause immediately so
Lubricating oil must be clean, and the oil level should be kept in the red circle leveller.
Disconnect the plug to cut off the power supply and open the outlet valve.
220V / 230V / 240V Single Phase
Clean the crankcase and renew the lubricating oil after the first 10 working hours.
Clean the oil level after every 20 working hours and replenish if necessary.
Open the drain cock under the tank to exhaust condensate after every 60 working hours.
Summary of Contents for W3D1/24
Page 10: ...9 11 PARTS ILLUSTRATION...
