* These steps are identical for the Amp and PSU. Both units must be connected prior use.
Connecting umbilical cord
Alignment dots
Amp / PSU
power socket
Plug ring
Plug sleeve
1. Hold the plug sleeve.
2. Align the socket and plug by aligning the two red dots.
3. Insert plug gently into the socket. You should hear a
clicking sound when the plug is securely in place.
* Never turn the plug ring. It moves backward and forward
Disconnecting umbilical cord
1. Grip the plug ring.
2. Pull awey from the socket. The ring should
retract and release from the socket.
Do NOT transport amplifier with umbilical cord attached.
Disconnect and pack umbilical cord separately.
FRONT
4-pin XLR
Headphone Output
Output Mode
Pre-amp / Headphone
Impedance Mode
High / Low
Power
ON / OFF
Volume control
Output level
High / Low
Input Selection
1 / 2 / 3
1/4”
Headphone Output
BACK
RCA
input
1
2
RCA input
(RCA shorting caps
pre-installed)
XLR
Input
3
Umbilical cord
connector
Fuse compartment
AC Power
cord inlet
XLR preamp output
(XLR to RCA adapter
can be used,
sold separately)
Umbilical cord
connector
AC 115V / 220V
