SETUP & OPERATION
Up/Down Operation
Operation
EGdoc030112
4-16
4
4.4.3 Up/Down Operation
Set the cutter head at the desired height. The height scale shows the height of the
cutter with the knives above the bed rails.
IMPORTANT!
Remember that the maximum planing thickness can be 4 mm.
1.
Pull back the crank handle to engage the locking pins for up/down operation.
2.
Loosen the locking handle.
3.
Turn the crank handle clockwise to raise the head or counterclockwise to lower the head.
4.
Secure the head in the desired position using the locking handle.
See Figure 4-4.
CAUTION!
DO NOT try to force the head above the 64,5 cm mark or
below the 5,5 cm mark on the height scale. Damage to the up/down
system may result.
FIG. 4-4
WMM026C
Locking Handle
Crank Handle
