SETUP & OPERATION
Feed Operation
4
4-17
EGdoc030112
Operation
4.4.5 Feed Operation
1.
Push the crank handle to engage the locking pins for feed operation.
2.
Turn the crank handle clockwise to move the head forward or counterclockwise to move the head
backward.
See Figure 4-6.
DANGER!
Always firmly hold the safety handle and the feed crank
handle. Be aware that the moulding head can move towards you when
you are working with hard wood or if the material is not secured
properly. The planing head can be moved by using the crank handle
only. Never push or pull the planing head manually.
3.
It is possible to adjust the cutter right or left. The maximum adjustment available is 110mm. To slide
the cutter, first loosen the locking knobs (4). Use the cutter scale to measure the distance from the
initial position. (When the cutter is in the extreme left position, the cutter scale shows 0.)
IMPORTANT!
Always make sure that all locking knobs are firmly tightened before using the moulder.
FIG. 4-6
WMM027C
