SETWORKS OPERATION
Memory Buttons (A, B, C, D, E)
SETWORKS OPERATION
EGdoc030112
5-5
5
shows the same distance. If not,
for the alignment instructions.
Enter the measured distance without a pause. For example: if you want to enter 250mm - press
2-5-0-0
without a pause. Confirm by pressing
.
5.3
Memory Buttons (A, B, C, D, E)
After switching-on, the “MPS-01” inscription appears on the display, and the Setworks is ready for
operation within a few seconds or after
is pressed.
The Setworks is designed to automatically lower the cutter (by 1 - 5 mm) below its current position.
IMPORTANT!
Remember that the maximum planing thickness can be 4 mm.
To automatically lower the cutter, enter the required value (from 1 to 5mm) using the keypad and
press
. The cutter will automatically be lowered by the entered value.
You can also change the cutter position using
.
You can store up to five values using the memory buttons.
To store the value, press and hold
. The inscription “ABC” will appear on the upper display.
Press the memory button (A, B, C, D or E), enter the value and confirm by pressing
.
Perform the same procedure for other memory buttons.
SAVE
ENTER
ENTER
SET
ABCDE
SAVE
