SPECIFICATIONS
Moulder Specifications
Specifications
EGdoc030112
7-4
7
See Table 7-6.
The noise level of the MP100/150 moulder is given below.
1
2
See Table 7-7.
See the table below for planing/moulding material specifications
.
See Table 7-8.
Other specifications of the moulder are listed below.
Equivalent Noise Level
Under Load
MP100/150 Moulder
Equipped With E5 Electric Motor
L
Aeq
Te = 98 dB (A)
TABLE 7-6
1. The noise level measurement was taken in accordance with PN-EN ISO 3746 Standard.
2. The measured values refer to emission levels, not necessarily to noise levels in the workplace. Although there is
a relation between emission levels and exposure levels, it is not possible to determine with certainty if preventives
are needed or are not needed. The factors affecting a current level of noise exposure during work are inter alia
room characteristics and characteristics of other noise sources, e.g. number of machines and machining
operations nearby. Also, the permissible exposure level value may vary depending on country. This information
enables the machine’s user to better identify hazards and a risk.
Minimum Cant Height
60 mm
Maximum Cant Height
600 mm
Maximum Cant Width
1
1
Using horizontal adjustment
520 mm
TABLE 7-7
Cutter Specifications
Number of Knife Sockets
4
Cutter Diameter
122 mm
Cutter Width
410 mm
Cutter Horizontal Adjustment
110 mm
Cutter Rotations
4890 rpm
Specifications of Knives
Straight Knife Height “A”
27-35 mm
Straight Knife Thickness “B”
2-3 mm
Straight Knife Protrusion “C”
1.1 mm
Pattern Knife Thickness “B”
3-5 mm
Pattern Knife Max Protrusion “C”
depends on the knife
thickness (see table 7-9)
TABLE 7-8
