MOULDER ASSEMBLY
Head Assembly
MOULDER ASSEMBLY
15doc030112
3-17
3
See Figure 3-9.
CAUTION!
The top of the leg should not be higher than the top surface of
the bed rail.
3.5
Head Assembly
1.
Position the head at the end of the bed frame assembly. Carefully slide the head rollers onto the bed frame
track. Keep the head square to the bed to avoid putting the track rollers in a bind.
WARNING!
When setting the head on the bed frame, use extreme caution
and keep all persons at a safe distance. Failure to do so may result in
serious injury or death.
2.
Install the middle track cover with a felt strip using a 6.4 flat washer and M6x12 hex head bolt.
FIG. 3-9
25mm
Foot Plate
