SETUP & OPERATION
Mounting the Planing Knives
Operation
EGdoc030112
4-6
4
4.2
Mounting the Planing Knives
WARNING!
Always shut off the motor and allow all moving parts to
come to a complete stop before mounting/dismounting the knives.
WARNING!
Always wear gloves and eye protection when
mounting/dismounting the knives. The knives are very sharp. You can
hurt yourself even when you touch any knife lightly.
WARNING!
Before mounting the knives, make sure the knives, the
mounting strip and the cutter sockets are immaculately clean. Any
sawdust or resin inside the cutter may cause the knife to break.
Damaged knives or mounting strip should be replaced immediately.
IMPORTANT!
The knives must be mounted in pairs. It is possible to
mount only two knives in opposite sockets, but we recommend that the
knives be mounted in all four sockets.
1.
Turn the key switch to
position to loosen the motor brake.
2.
Remove the cutter cover.
FIG. 4-3
!
