SETUP & OPERATION
Up/Down Operation
4
4-21
EGdoc030112
Operation
4.5.3 Up/Down Operation
Set the cutter head at the desired height. The height scale shows the height of the cutter with the
knives above the bed rails.
IMPORTANT!
Remember that the maximum planing thickness can be 4 mm.
1.
Set the key in
position.
2.
Push the up/down drive switch to set the head height.
See Figure 4-4.
CAUTION!
DO NOT try to force the head above the 64,5 cm mark or
below the 5,5 cm mark on the height scale. Damage to the up/down
system may result.
FIG. 4-4
WMM082
