SETUP & OPERATION
Machine Start-Up (MP150)
Operation
EGdoc030112
4-26
4
4.7
Machine Start-Up (MP150)
DANGER!
Before starting the machine, perform the following steps to
avoid injury and/or damage to the equipment:
Close or mount any covers removed for service.
Check that the wood to be planed/moulded is properly secured.
Make sure that all persons are at a safe distance from the machine.
Turn on the dust extraction system.
Check if the emergency stop button is released.
NOTE:
The machine will not start if the emergency stop is on.
To start moulding/planing:
1.
Set the head height as desired using the up/down buttons.
2.
Turn the main switch on the electrical box to the ON position.
3.
Press AND HOLD the safety button
.
NOTE
:
If the safety button is released, the cutter disengages and
stops.
4.
Turn the key switch to
position.
