Safety
Safety Instructions
2
2-13
HD97doc041910
Safety
Restoring Equipment to Service
1.
When the job is complete and the Sawmill is ready for testing or normal service, check
the Sawmill area to see that no one is exposed.
2.
When the Sawmill is all clear, remove all locks. The energy isolating devices may be
operated to restore energy to the Sawmill.
Procedure Involving More Than One Person
In the preceding steps, if more than one individual is required to lock out the Sawmill,
each shall place his own personal lock on the energy isolating devices.
Rules for Using Lockout Procedure
The Sawmill shall be locked out to protect against accidental or inadvertent operation
when such operation could cause injury to personnel. Do not attempt to operate any
switch or valve bearing a lock.
Owner’s Responsibility
The procedures listed in this manual may not include all ANSI, OSHA, or locally required
safety procedures. It is the owner/operator’s responsibility and not Wood-Mizer Products
to ensure all operators are properly trained and informed of all safety protocols.
Owner/Operators are responsible for following all safety procedures when operating and
performing maintenance to the Sawmill.
