Cascade Gas-Fired Rotisserie & Charbroiler
Installation and Operation Manual
8
An ongoing program of product improvement may require us to change
specifications without notice.
WS-GFR-MB, Revised November 2014.
Doc no: M0050.01
info@woodstone-corp.com
or visit
woodstone-corp.com
wood stone corporation
1801 w. bakerview rd.
bellingham, wa 98226 usa
tf. 800.988.8103
t. 360.650.1111
f. 360.650.1166
ASSEMBLY
STEP 1: LEG / CASTER POSITIONING & ASSEMBLY
The legs/casters of the rotisserie must be installed in its proper position prior to setting the unit in place� Each leg is numbered,
corresponding to the number written on the underside corners of the cabinet body�
The rotisserie must be raised more than 23 inches from the floor in order to mount the legs� Each leg is firmly attached using the
four 3/4 inch bolts provided� Once all four legs are securely attached, the rotisserie can be lowered into place�
Seal all legs to the
cabinet using the silicone sealant provided.
IMPORTANT NOTICE FOR GAS CONNECTION TO MOVABLE APPLIANCES
When this appliance is installed with casters, it must be installed with the casters supplied, a connector complying with either
ANSI Z21�69 or CSA 6�16 and a quick disconnect device complying with ANSI Z21�41 or CSA 6�9� It must also be installed with
restraining means to guard against transmission of strain to the connector, as specified in the appliance manufacturer’s instructions�
ATTENTION INSTALLER: EQUIPMENT RESTRAINT MUST BE PROVIDED
Adequate means must be provided to limit the movement of the appliance without depending on the connector and the quick
disconnect device or its associated piping to limit the appliance movement� Use the holes in the lower rails of the rotisserie
cabinet and charbroiler table to attach the restraining device(s)�
STEP 2: INSTALL SKIRTING
The front skirt is removed for shipping, and must
be reinstalled after the legs/casters are installed�
Align skirting with the pre-tapped holes in the legs
and attach with (6) 10-32 x 1/2" stainless steel
pan head machine screws (supplied) as shown at
right�
REV:
DATE:
PART #:
Bellingham, WA 360/650-1111 www.woodstone-corp.com
001-805-L-MB
LH Drive w/ Montague Broiler
General Arrangement
2/27/2014
bena
1
DIMENSIONS ARE IN INCHES
TOLERANCES: LINEAR ±1/2 [±10mm], ANGULAR ±2°
UNLESS NOTED OTHERWISE
DWN BY:
SHEET:
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF WOOD STONE CORPORATION
ANY REPRODUCTION OR USE IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF WOOD STONE IS PROHIBITED
An ongoing program of product improvement may require us to
change specifications without notice.
C:\Users\bena\Desktop\001-805_GFR-1.dft
1 of 1
(6) 10-32 x 1/2" stainless steel
pan head machine screws
ASSEMBLY