R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
R
WOODBRIDGE
www.woodbridgebath.com
12
READ BEFORE INSTALLATION:
1. Installer MUST follow the circuit diagram and technical data provided by manufacturer during the
installa on.
2. Ground onthe control panel must connect to circuit diagram with ground.
3. Installer must use a cer
fi
ed speci
fi
ca on of 3x3mm diameter or thicker wire, and power outlet must
be 30A or higher grand for installa on.
4. Installer MUST buy a 30A or higher grade of Air switch or leakage switch. The leakage switch on unit
itself is for support use only.
5. Check and make sure the wiring and rou ng on wiring hub is correct per speci
fi
ca on. use only when
it is per factory speci
fi
ca on.
6. DO NOT apply any non-factory cer
fi
ed components or equipment to the control panel, it is prohibited
to disassemble or modify any of the wiring or unplug and reconnect the wire when it Power box is s ll
with power.
7. The wiring and connec on on power box must match with the diagram, output cannot be short circuit.
8. It is highly recommended to shut down the unit a er use to prevent aging caused by con nuous electric
current.
9. Control Box must be installed by cer
fi
ed installer and following installa on instruc on.
10. None of the component inside the control box can be resume, DO NOT try to improve nor repair.
High voltage inside the control box will caused severe body injury. Any maintenance or alignment
must be serviced by cer
fi
ed technician.
[DISCLAIMER]
1. This product must be serviced by cer
fi
ed technician authorized by manufacture or it’s dealer or
warranty will be voided, and manufacture has no responsibility to any cost or lost caused.
2. This installa on manual is for reference only and is subject to change without any prior no ce.
