ONE PIECE SQUARE TOILET
CLEANING & TROUBLESHOOTING (FILL VALVE)
Shut off water supply line
before filter cleaning.
Water level is too high or
too low
Improper water level
adjustment
Adjust the water level
Fill valve fails to shut off
or fails to fill the water
into the toilet's tank
Use soft sponges or soft-cloths to clean the surface. Always rinse thoroughly any cleaning solutions immediately after cleaning. Do
not any chemical remain on the surface for extended periods of time.
Do not pour any mounts of chlorine or any other chemicals into the tank. Use of chemical products will result in damage to the fill valve and
flush valve components and may cause flood and property damage
Note:
fill and flush valves are maintenance free. No maintenance is required.
1. Inlet valve switch is
turned on.
2. Inlet valve float crashed
against ceramic wall
3. Filter screen is clogged
due to dirty water
4. Improper refill hose
installation
1. Turn on inlet valve switch
2. Adjust inlet valve position
3. Clean the filter screen
4. Install refill hose correctly (see
diagram on the right)
Carefully, take out the filter
from inlet by using pliers.
Use water to wash and clean
the filter and adapter from any
debris.
Re-install the filter and
re-connect the water supply
line.
FILL VALVE CLEANING
TROUBLESHOOTING
FILL/FLUSH VALVES MAINTENANCE & CARE
MAINTENANCE & CARE
Issue
Cause
Solution
Solution #4
RIGHT
WRONG
Water
Level
Retain these installation instructions for future reference!
Thank you for using our products!
IMPORTANT!
DO NOT USE:
Abrasive cleaners such as: acid, ammonia, bleach, and simmilar solutions. Use of such solutions may cause
corrosion, finish peeling, and/or dull the surface.
DO NOT USE:
Abrasive sponges or cloth. Never use steel, wool, or wired brushes that will permanently scratch the surface.
9
