R
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
R
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
R
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
R
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
R
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
R
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
R
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
R
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
WOODBRIDGE
www.woodbridgebath.com
R
WOODBRIDGE
10
REMOTE CONTROL ILLUSTRATION
Usage Instruction
Night light
Press “STOP” button, then “DRY” button, night light will be often in the off state;
Repeat the process, night light will switch to intelligent state. Repeat above process
constantly, the night light will switch between off state and intelligent state.
Quiet mode
Press “STOP” button and then “MASSAGE” button to turn off buzzer to avoid noise in
the night; Repeat the process to start buzzer function.
User code
The user code needs to be set to avoid disturbance from remote controls when more
than one toilets are used in the house.Turn on the toilet for setting while turn off others.
(1) Press“STOP”button and then“REAR” button to enter into user code setting.
The remote control shows only water pressure and spray position level,and characters
are blinking on the screen.
(2) Press water pressure buttons of “+”and “-”,to choose user code 1-9.
(3) Press“STOP”button and then“REAR” button again,remote control will save the
setting and exit user code setting window,the buzzer will ring “click” to indicate
successful setting.
The sum of water pressure and position level on LCD is the user code.Restart to clear
the user code and re-set.
Automatic flush button
Press “STOP” button and then “FLUSH” button to start or close automatic flushing function.
When the automatic flushing function is turned on, toilet will automatically flush after
detecting user sitting for more than 6 seconds and leaving the seat for more than
3.5 seconds.
Combination button
Remark:
By pressing the button, the signal indicator will flash which means the signal is sent
out;Then the buzzer rings “click”, which means the main unit receives the signal and
executes the instruction. If the signal indicator doesn't flash, that means the button is not
efficiently pressed and needed to be re-pressed. If the buzzer does not ring, that means the
main unit doesn’t receive the signal. Please regulate the remote control direction and
re-press the button.
In case of power cut during wand’s spray operation, the wand cannot go back to
place,please wait until the power is reset. In case of a power cut for a long period, please
push the wand softly back by hand. Do not push hard, to avoid damage to wand and
electrical machine.
The body should touch the seat and the buzzer rings “click”, which means functions of
front cleaning, rear cleaning and drying are in operation. The nozzle will continue to spray for
1-2 seconds after user stands up during spray operation, so please press"STOP" button
before standing up.
Use nozzle self-cleaning function after user leaves the seat. After cleaning, if user doesn't
press "NOZZLE CLEANING" or "STOP" button, nozzle wand will go back after 10 minutes or
user sits on the seat.
