Woodbridge B0960S Installation And Care Manual Download

Page: 4 / 20

WOODBRIDGE

www.woodbridgebath.com

WOODBRIDGE

CAUTION

– Indicates that failure to follow the instruction may cause body injury or property damage.

GROUNDING INSTRUCTIONS

This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current. This product is equipped with a cord
having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly
installed and grounded.

DANGER

– Improper use of the grounding plug can result in a risk of electric shock.

If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either ﬂat

blade terminal. The wire with insulation having an outer surface that is green with or without yellow
stripes is the grounding wire.

This product is factory equipped with a speciﬁc electric cord and plug to permit connection to a proper
electric circuit. Make sure that the product is connected to an outlet having the same conﬁguration as
the plug. No adapter should be used with this product. Do not modify the plug provided — if it will not ﬁt
the outlet, have the proper outlet installed by a qualiﬁed electrician. If the product must be reconnected
for use on a different type of electric circuit, the reconnection should be made by qualiﬁed service

personnel.

SAVE THESE INSTRUCTIONS

1. Do not install or use the product in wet places as steam room etc.This product must be connected to
properly grounded power outlet socket.
2. It is recommended to use water-proof electrical outlet which should be lnstalled in the place where is
not easily got wet.
3. This product should be used with AC 110V-120V,50/60Hz electrical current only,load current is at
least 15A. P ower plug must be equipped with ground fault circuit interrupter or ground fault electrical
leakage protector or similar high sensitive, rapid type leakage switch (Rated sensitive current under
6mA).
4. When it thunders,it is strongly recommended to pull out the power plug.
5. Do not stand on ceramic toilet.

6. Ceramic toilet must install ﬂoor ﬁxing bolt.

7. Do not stand on product unit,seat and cover.
8. Do not lean against the seat cover when using the product,to avoid damage.
9. This product is equipped with soft-closing seat cover.Heavy pressing or pushing may damage the
soft-closing damper.
10. Do not use lacquer thinner,petrol,liquid medicine,detergent,insecticide,toilet cleanser and scrubbing
brush to clean the product.
11.Exposure to direct sunlight is prohibited.

12.Only use tap water or bottle water;otherwise it may cause chaﬁng.

13.Do not connect water supply to heater outlet.Make sure inlet water temperature at 3~35

℃

14.When the room temperature is under zero degree,please dry up the water tank,to avoid freezing.
15.Raise rest room temperature to prevent the toilet from damage due to freezing.
16.When move the product from cold or wet environment into normal room temperature,wait for 2 hours
until the condensation water is fully volatilized.Doing so can prevent the product from electric short
-circuit.
17.When not using the product over three(3) days,drain the water out of the container and pull the
elelctrical plug from the wall outlet.

ELECTRONIC BIDET TOILET

18.Stop using the product and shut off the power when product
malfunctions,please contact the service people for professional service.