6
Install-Std-120906
Thank you for purchasing a Woodfold door.
5 u
PkeeP
anD
c
are
S
uggeStionS
OK! Now the door is installed, let’s review it’s love and care.
Operation/Maintenance
•
For proper operation the track must be securely attached to the header, plumb and level. Vertical jambs must be perpendicu-
lar for proper operation. Use instructions for proper installation
•
Do not rapidly pull or force any folding door across openings or around corners
•
The hinge system may be stiff initially and will gradually ease after a period of time with regular use
•
During normal use of your Woodfold door watch for instances of binding during movement. If there is binding, inspect the
track for loose screws, dirt, debris and wheel alignment.
•
Track may be periodically lubricated with a petroleum jelly type material. Do not use aerosol lubricants
Care/Cleaning
•
Avoid exposure to excess or continued moisture
•
As with all materials, exposure to light will cause fading
•
Regular cleaning of the Vinyl/Acrylic/Aluminum/Veneer- use mild soapy water then dry with a soft cloth or chamois. Do NOT
use household cleaners, abrasive towels or scouring pads.
•
Wood veneer doors can be treated periodically using a furniture polish/cleaner
•
Acrylic/Aluminum panel doors can be treated periodically with non-abrasive anti-static cleaner to reduce dust accumulation
Check it out!
Open and close the door a few times then step back and admire your work.
Installation is complete!
Magnetic Latch
Dry fit the Interlocking Jamb Molding against the wall, directly under the
track. It should fit snugly against the wall and the track at the top. Each
jamb molding is pre-cut to fit the opening, however, trim the molding
with a hacksaw if needed.
Attach the Interlocking Jamb Molding to the wall with #6 x 1½” flat head
screws.
Center the Strike Plate on the magnet with the adhesive side out. Re-
move the protective tape from the adhesive backing and push the door
firmly shut.
When you re-open the door, the strike plate should stay temporarily
stuck in position. Drill through the center of each strike plate screw
hole and Interlocking Jamb Molding using a 5⁄32” drill bit. Screw
down the strike plate using 1½” #6 Flat head screws.
Lead Post with
Magnetic Cartridge
(Rotated for visual clarity)
Interlocking
Jamb Molding
Steel strike plate
with adhesive backing
#6 x 1½” flat
head screws
#6x1
½
” F
la
t Head
