1826
Drill Press Table
Please Read Carefully!
1
BEFORE BEGINNING
Identify and verify that you have all the parts listed. Read
the instructions at least once, familiarizing yourself with the
parts and assembly instructions before beginning. You’ll need a
#3 Phillips screwdriver and a 7/16" wrench for assembly.
ASSEMBLY
Insert a 1" screw
(MF015)
thru the four countersunk holes
in the drill press table
(1826A),
place the table upside down on
a flat surface and start an oval nut
(5760B - raised side first)
on the end of the screws. Slide a 8" Ultra Track
(4408)
on two
oval nuts until it's centered end-to-end on the oval nuts and the
face of the Ultra Track is flush with the edge of the drill insert
(1826B)
opening, then tighten the screws.
See fig. 1 & upper
inset photo.
Install two 1" washers
(WFN002)
on each 3/4" bolt
(HB020)
, insert the bolts thru the holes in the leveler
(1826D)
and start an oval nut
(5760B - raised side first)
on the bolt ends.
Install the levelers on the Ultra Track by inserting the
oval nuts into the T-slot of the track. Position the levelers over
the drill insert, with the edge of the levelers resting against the
underside of the drill insert, tighten the bolts.
See fig. 1 & lower inset.
Parts List:
Part Description
Quantity
1826A
Drill Press Table . . . . . . . . . . . . . . . . . . . . . . . 1
1826B
Drill Insert . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
1826C
Square Washer . . . . . . . . . . . . . . . . . . . . . . . . 4
1826D Leveler
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
4408
8” Ultra Track . . . . . . . . . . . . . . . . . . . . . . . . . 2
NUT015
Nut . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
HB050 1-1/2"
Bolt
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
HB020
3/4" Bolt . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
MF015
1" Screw . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
WFN002
1" Washer . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
5760B
Oval Nut . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
WL001
Lock washer . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
1826D
4408
4408
1826D
