ATTACH TABLE & FENCE BRACKETS
Install eight 1-1/4” flat head screws
(MF020)
thru the countersunk holes in the phenolic table
(6000T)
and start an oval nut
(5760B - smooth
side first)
on the ends of the screws. The four
screws/oval nuts in the main field of the table
are used to attach the table to the 9-1/4”
tracks. Slide the table/four oval
nuts onto the tracks, position
the table so its approximately
1/32” from the face of the router
plate and tighten the screws.
5771B x4
MF020 x4
5760B x8
5771B x4
MF020x4
5760B x8
From each side of the table,
slide a 4” double track
(4004)
onto
two oval nuts on the underside of
the table so the T-slot in the edge of
the track faces towards the edge of
the phenolic table and hangs past
it slightly. Center the track on the
oval nuts and tighten the screws.
Insert a 3/4” screw
(5771B)
thru the holes in the phenolic fences
(6000D)
and start an oval nut
(5760B
- smooth side first)
on the ends of the
screws. Slide the oval nuts/fences onto
each 4” double track, position the end
of the fence 1/32” from the edge of the
plate, then tighten the screws. Using a
straight edge, loosen the screws holding
the 4” double tracks on the phenolic
table and adjust the fence faces so
they’re in line with the face of the
router plate, then re-tighten the screws.
60
00
T -
Ph
en
oli
c T
ab
le
60
00
D
40
04
