4. The speed can be changed during the opera on of the centrifuge, upon
changing the speed, the centrifuge will start running on the updated speed
for the remaining me le on the centrifuge cycle.
Note:
Centrifuge will not run with the lid open.
5. To set me press the TIME bu on first, then use INCREMENT and
DECREMENT bu ons, me can be set as desired me. The set me will be
displayed in the display window at the bo om.
6. The me range in this centrifuge allows user to choose between 1 min & 30
minutes & infinite mode. Infinity mode displayed as ][.
7. The centrifuge incorporates a count down mer, a er each minute of
opera on the value of the mer is reduced by 1 minute.
11.2 SWITCHING TO RCF DISPLAY
Press the RPM/RCF to change the mode from RPM to RCF, while in RCF mode the
speed value is to be read as value x 10 in the display window. The maximum RCF of
the centrifuge is 3684 / 3873 xg. Press the RPM/RCF to see corresponding RCF
value.
11.3 START & STOP OPERATION
Once all the parameters like Speed & Time are set, press the “Start”bu on to
START opera on.
1. Make sure that the lid is closed before star ng the centrifuge.
2. The display will keep on blinking un l the set parameters are (RPM/RCF &
Time) reached. Once the set parameters are reached, the display will blink
mul ple mes un l the set value is reached.
3. When centrifuga on is completed the lid of the centrifuge opens
automa cally and the mer value will again start blinking.
Press the STOP/LID bu on any me the centrifuge needs to be stopped.
A er every run the lid opens by itself. In any other case, when the lid needs to be
opened push the STOP/LID bu on to open the lid.
11.4 OPENING THE CENTRIFUGE LID IN CASE OF POWER FAILURE
Disconnect the centrifuge from the main
supply. Wait un l the rotor comes to a
stands ll (thismay take some me).
Once the rotor has stopped, pull out the
emergency lid release as shownin the
figure. This will open the centrifuge lid.
A er the centrifuge lid opens, push the
thread back in the hole with your hand
8
