Woodley Clinispin MPC, Operator'S Manual

page 13

CONTROL PANEL FUNCTIONS:

Predefined Pre-sets:

The centrifuge has Predefined Pre-sets for easy accessing of commonly used 

operations. After closing the centrifuge lid, a single press of any  pre-set 

button will display the pre-set ‘speed’ and ‘time’ to be used. Below are the 3 

available pre-sets buttons. 

1) SERUM / PLASMA (For Microtube rotor)

This “SERUM / PLASMA” button has the pre-defined speed & time value of 12000 

RPM & 2 minutes respectively. Single press the “SERUM / PLASMA” button to start 

operation at 12000 RPM for 2 minutes of time. Once the button is pressed, the 

predefined speed and time will appear in the display. 

2) HCT / QBC (For HCT rotor) 

This “HCT / QBC” button has the pre-defined speed & time value of 12000 RPM &    

5 minutes respectively. Single press the “HCT / QBC” button to start operation at 

12000 RPM for 5 minutes of time. Once the button is pressed, the predefined speed 

and time will appear in the speed and time buttons display. This may be amended

This may be amended manually
 

if required with the ‘time’ and ‘speed’ buttons. 

manually if required with the ‘time’ and ‘speed’ buttons. 

3) URINE (For Microtube rotor)

This “URINE” button has the pre-defined speed & time value of 1000 RPM &            

1 minute respectively. Single press the 

 to start operation at 1000 

“URINE” button

RPM for 1 minute of time. Once the button is pressed, the predefined speed and time 

will appear in the display. This may be amended manually if required  with the ‘time’

and ‘speed’ buttons.