STEPS 1 - 5: INSTRUCTIONS FOR UNPACKING AND PREPARATION FOR ASSEMBLY
STEP 1
STEP 4 - ALIGNING ROOF STRUCTURE WITH VERTICAL STRUCTURE AND GEAR BOX
STEP 5 - ALIGNING THE ROOF STRUCTURE WITH 2ND VERTICAL STRUCTURE
STEP 2
STEP 3
REMOVE THE ROOF STRUCTURE & CANOPY FROM THE PROTECTIVE TUBE. THE WOODEN
END PLUGS ARE SECURED USING SCREWS WHICH MUST BE REMOVED TO GET THE END
PLUGS OUT.
NOTE: IT IS RECOMMENDED TO USE COTTON GLOVES WHEN HANDLING THE CANOPY
TO AVOID DIRTY MARKS ON THE CANVAS. ENSURE YOU ARE WORKING IN A CLEAN
AREA WITH AMPLE SPACE. IT IS ADVISABLE TO LAY THE ROOF STRUCTURE ON A
CLEAN SURFACE SO THE COVER BAG AND ROOF CANOPY DO NOT GET MARKS FROM A
DIRTY SURFACE. THE PLASTIC COVERING CAN BE USED FOR THIS PURPOSE.
USING SCISSORS, CUT DOWN THE LENGTH OF THE PLASTIC BAG CONTAING THE ROOF
STRUCTURE. THE CLEAN INNER SURFACE CAN THEN BE USED AS A WORKING SURFACE.
CUT THE CABLE TIES WHICH HOLD THE ROOF STRUCTURE TOGETHER (CENTER ROLLERS,
SIDE ROLERS AND CANOPY). BE CAREFUL TO NOT CUT OR DAMAGE THE FABRIC.
THE TWO ENDS OF THE PROTECTIVE COVER BAG ARE FOLDED BACK OVER THE ROOF
STRUCTURE. THESE MUST BE CAREFULLY PULLED OUTWARDS BEFORE UNZIPPING.
REMOVE THE PROTECTIVE COVER BAG BY UNDOING THE ZIPPER.
END PLUG
SCREWS
CABLE TIE
ROOF STRUCTURE
THERE ARE THREE (3) THREADED SHAFTS AT EACH END OF THE ROOF STRUCTURE. ONE END OF THE ROOF STRUCTURE HAS A SQUARE
SHAFT ON THE CENTER ROLLER. THIS SHAFT FITS INTO THE GEAR BOX ON THE VERTICAL STRUCTURE. BEFORE POSITIONING THE
VERTICAL STRUCTURES, DECIDE AT WHICH END YOU WANT TO POSITION THE GEAR BOX. THE GEAR BOX IS USED FOR OPENING
AND CLOSING THE STRUCTURE AND MUST BE ACCESSIBLE WITH THE CRANK HANDLE. THE MIMIMUM REOMMMENDED SPACE
REQUIREMENT IS 50cm (20 INCHES).
ONCE YOU HAVE DECIDED, PLACE THE VERTICAL STRUCTURE AT 90 DEGREES TO THE ROOF STRUCTURE SO THE GEAR BOX FACES
OUTWARDS. THE CHAINS WITH STAINLESS STEEL PINS ON THE VERTICAL STRUCTURE SHOULD ALSO FACE OUTWARDS (AWAY FROM
THE ROOF STRUCTURE).
GEAR BOX
VERTICAL STRUCTURE
SQUARE SHAFT
POSITION THE OTHER VERTICAL STRUCTURE AT 90 DEGREES, SO THE STAINLESS STEEL PINS WITH CHAINS
ARE FACING OUTWARDS.
ZIPPER
2|6
ROOF STRUCTURE
ROOF STRUCTURE
VERTICAL STRUCTURE
Distributor: Shadescapes Americas TEL: 970.527.7070 www.shadescapesamericas.com info@shadescapesusa.com © PROTRADE & WOODLINE cc. 2000
