STEP 6
FEMALE
PVC WASHER
STEP 7
MALE
PVC WASHER
3|6
It is recommened to
lubricate threaded shafts
to prevent the Nyloc nuts
from freezing due to friction
(Vaseline or copperslip is
recommended).
Crank Holder
STEP 6 - ATTACHING THE VERTICAL STRUCTURE WITH GEAR BOX TO THE ROOF STRUCTURE
•
IDENTIFY AND PROPERLY ALIGN THE PVC WASHERS IN THEIR CORRECT POSITIONS BETWEEN THE VERTICAL STRUCTURE AND ROLLERS
AS ILLUSTRATED.
•
ALIGN THE SQUARE SHAFT ON THE CENTER ROLLER WITH THE SQUARE OPENING ON THE GEAR BOX. INSERT THE SHAFT INTO THE GEAR BOX.
IF IT DOES NOT FIT PROPERLY, TURN THE BLACK CRANK HOLDER ON THE GEAR BOX UNTIL THE SQUARE HOLE IS ALIGNED AND INSERT.
•
PLACE THE FEMALE PVC SPACER AGAINST THE GEAR BOX ON THE OUTSIDE OF THE CENTER POLE AND ADD THE STAINLESS STEEL WASHER
AND NYLOC NUT.
•
INSERT THE THREADED SHAFTS ON THE SIDE ROLLERS INTO EACH OF THE SIDE ARMS AND ADD ALL THE STAINLESS STEEL WASHERS AND
REMAINING NYLOC NUTS.
•
TIGHTEN THE NYLOC NUTS TO THE POINT THEY HOLD FIRM , BUT THE ROLLERS STILL ROTATE FREELY.
STEP 7 - ATTACH REMAINING VERTICAL STRUCTURE TO THE ROOF STRUCTURE
•
IDENTIFY AND PROPERLY ALIGN THE PVC WASHERS IN THEIR CORRECT POSITIONS BETWEEN THE VERTICAL STRUCTURE
AND ROLLERS AS ILLUSTRATED.
•
INSERT THE THREADED SHAFTS ON THE SIDE ROLLERS INTO EACH OF THE SIDE ARMS AND ADD ALL THE STAINLESS STEEL
WASHERS AND REMAINING NYLOC NUTS.
•
TIGHTEN THE NYLOC NUTS TO THE POINT THEY HOLD FIRM , BUT THE ROLLERS STILL ROTATE FREELY.
NOTE: THE ROOF STRUCTURE IS A FREE
SPINNING SYSTEM. THE NYLOC NUTS
SECURING BOTH SIDES SHOULD ONLY BE
TIGHTENED TO THE POINT THE NYLOC NUTS
HOLD FIRM, AND THE ROLLERS STILL ROTATE
FREELY.
Gear Box
Standard
PVC Washers
Standard PVC Washers
Distributor: Shadescapes Americas TEL: 970.527.7070 www.shadescapesamericas.com info@shadescapesusa.com © PROTRADE & WOODLINE cc. 2000
