4|6
STEP 8
STEP 9
STEP 12 - SECURING THE ROOF STRUCTURE
STEP 11 - OPENING TO THE SECOND POSITION
NOTE:
EACH SIDE CAN BE LIFTED INDEPENDENTLY BY ONE
PERSON. THERE IS NO NEED FOR TWO PEOPLE TO LIFT EACH
SIDE SIMULTANEOUSLY.
•
TO OPEN THE ROOF STRUCTURE COMPLETELY, RAISE THE
SIDE ARMS OF THE VERTICAL STRUCTURE BY LIFTING THE
VERTICAL RUNNER ON THE CENTER POLE TO THE STOPPER
POSITIONED AT THE TOP OF THE CENTER POLE.
•
LIFT THE RUNNER USING ONE HAND, AND INSERT THE
SECURING PIN BELOW THE BOTTOM OF THE RUNNER WITH
THE OTHER HAND.
1.6m
Min
(5’ - 3”)
1.6m
Min
Center L
ine
Measured
from
Tube
Center to
Tube C
enter
(5’ - 3”)
CLOSING
REFER TO THE OPENING STEPS IN REVERSE ORDER.
BEFORE LOWERING THE VERTICAL RUNNER, REMOVE THE LOCKING
PINS FROM THE WIND STABILIZING RUNNERS.
FIRMLY GRAB HOLD OF THE VERTICAL RUNNER BEFORE REMOVING
THE SECURING PIN. THE VERTICAL RUNNER MUST THEN BE
LOWERED GENTLY UNTIL IT IS PLACED ON THE STOPPER AT THE
BOTTOM OF THE VERTICAL POLE. FAILING TO HOLD THE RUNNER
FIRMLY, WILL RESULT IN THE RUNNERS SLAMMMING DOWN ONTO
THE STOPPER AND MAY RESULT IN DAMAGE TO THE STRUCTURE.
REPEAT THE SAME PROCEDURE ON THE OPPOSITE SIDE.
WHEN BOTH SIDES ARE DOWN, PROCEED TO ROLL UP THE ROOF
STRUCTURE BY TURNING THE CRANK HANDLE UNTIL ALL THE
FABRIC IS ACCUMULATED OVERHEAD.
NOTE: BEFORE CLOSING OR COVERING WITH A PROTECTIVE COVER
BAG THE FABRIC CANOPY SHOULD BE DRY. IF THE FABRIC CANOPY
IS CLOSED OR PACKED AWAY WHEN WET, IT MAY RESULT IN
PERMANENT STAINING.
MAKE SURE THE SELECTED BASE SYSTEM IS IN THE CORRECT POSITION BEFORE RAISING THE ASSEMBLED
PAPILLON STRUCTURE AND PLACING IT IN THE STAINLESS STEEL TUBES.
•
THE STAINLESS STEEL TUBES MUST BE ALIGNED AND POSITIONED SO THE CENTER TO CENTER
DISTANCE EXACTLY MATCHES THE LENGTH OF THE ROOF STRUCTURE.
•
FOR THE 5m ROOF STRUCTURE THE DISTANCE FOR FROM CENTER TO CENTER OF THE STAINLESS STEEL
TUBES IS EXACTLY FIVE (5) METERS.
•
THE CENTER LINE MUST BE AT LEAST 1.6 M (5’ 3”) AWAY FROM THE NEAREST OBSTRUCTION ON BOTH
SIDES (IN THE DIRECTIONS THE CANOPY OPENS).
•
SEE SEPARATE INSTRUCTIONS FOR BASE SYSTEM ASSEMBLY DETAILS. INSTRUCTIONS ARE
INCLUDED IN THE BASE SYSTEM BOX.
USE TWO PEOPLE TO LIFT BOTH VERTICAL STRUCTURES INTO POSITION SIMULTANEOUSLY.
LOWER THE TWO VERTICAL STRUCTURES INTO THE STAINLESS STEEL TUBES AT THE SAME
TIME. ONCE IN POSITION, THE HAND WHEELS ON THE STAINLESS STEEL TUBES CAN BE
TIGHTENED TO SECURE THE POLES IN POSITION.
STEP 10 - OPENING THE PAPILLON - TO FIRST POSITION
INSERT THE CRANK HANDLE INTO THE CRANK HOLDER ON THE GEAR BOX AND TURN THE CRANK HANDLE.
•
THE DIRECTION OF ROTATION TO OPEN OR CLOSE THE ROOF STRUCTURE IS DETERMINED
BY THE ROTATION DIRECTION WHEN IT WAS LAST CLOSED. THIS MAY VARY EACH TIME
THE PRODUCT IS OPENED AND CLOSED.
•
WHEN OPENING, MAKE SURE THE ROOF STRUCTURE OPENS FREELY. THE WEIGHT OF THE
SIDE ROLLERS IS WHAT HELPS THE ROOF STRUCTURE TO OPEN FREELY AS THE FABRIC CANOPY
IS UNWOUND.
•
DO NOT FORCE THE ROOF STRUCTURE OPEN IF IT SEEMS TO BE JAMMING. THIS MAY RESULT
IN DAMAGE TO THE CRANK HOLDER OR GEAR MECHANISM.
•
IF THERE IS ANY RESISTANCE WHEN OPENING, MAKE SURE THE CENTER AND SIDE
ROLLERS MOVE FREELY. IF THE ROLLERS DO NOT MOVE FREELY, CHECK
THE NYLOC NUTS. THESE MUST NOT BE OVER TIGHTENED AND SHOULD ALLOW
ENOUGH SPACE FOR FREE MOVEMENT. IF THEY ARE TOO TIGHT, LOOSEN THEM.
•
WHEN THE ENTIRE FABRIC CANOPY HAS BEEN UNROLLED, THE ROOF STRUCTURE WILL BE IN THE FIRST
STAGE OF OPENING (SEE ILLUSTRATION). THE ROOF STRUCTURE CAN BE LEFT IN THIS POSITION IF REQUIRED.
THIS POSITION WILL ALLOW ADDITIONAL SHELTER FROM WET WEATHER AND ALLOWS RAIN RUN-OFF.
IT IS ALSO A CONVENIENT POSITION IF THE SUN IS AT LOW ANGLES.
FIRST STAGE OF OPENING
SIDE ARM
VERTICAL RUNNER
ONCE IN THE FULLY OPEN POSITION,
SECURE THE WIND STABILIZING SYSTEM BY INSERTING
THE LOCKING PINS THROUGH THE STABILIZER RUNNERS
AND INTO THE SIDE ARMS. IF THE HOLES ARE NOT
ALIGNED, LIFT OR PULL THE SIDE ARM(S) DOWN TO GET
ALIGNMENT.
NOTE: WHEN COMPLETELY OPEN AND THE SECURING PINS ARE IN POSTION,
THE CANOPY CAN BE LEVELED BY TURNING THE CRANK HANDLE IN THE REQUIRED
DIRECTION UNTIL THE ROOF STRUCTURE IS LEVEL.
SIDE ARM
CENTER PIN
STABILIZER PIN
WIND STABILIZER
WIND STABILIZING
SYSTEM
STOPPER
PIN
Distributor: Shadescapes Americas TEL: 970.527.7070 www.shadescapesamericas.com
info@shadescapesusa.com © PROTRADE & WOODLINE cc. 2000
