Operation
Starting The Engine
1
1-1
doc062309
Operation
SECTION 1 OPERATION
1.1
Starting The Engine
Control Lights
See Figure 1-1.
The following indicator lights are located on the sawmill control panel.
Alternator Charge Indicator:
Lights up if the alternator is not charging the battery.
Engine Temperature Indicator:
Lights up if the engine is overheating.
A circuit breaker
assembly in the engine harness will shut the engine off if the engine overheats. Turn the
key switch off and allow the engine to cool for a period of time before restarting. If the
overheating condition persists, stop operating the engine until the condition is corrected.
The engine will automatically switch to low idle if an overheating condition occurs.
Oil Indicator:
Lights up if the oil pressure is too low.
Glow Plug Indicator:
Lights up after the key has been turned to the on (#1) position.
FIG. 1-1
SW-08 Setworks
Real Size (mm)
Error calibration
Start autoprogram
AUTO
CAL.
SIZE
A,B,C
Position Size (mm)
NEXT CUT
A
B
C
Delete PROG.
Exit PROG.
PATTERN DOWN
Save PROG.
SAVE
PATTERN UP
BUMP UP
PROGRAM
