Electrical Information
Electrical Information
D42doc110909
5-1
4
SECTION 4 ELECTRICAL WIRING DIAGRAMS, D42
IMPORTANT!
When using a sawmill with the rewired con-
trol panel it is very important not to switch between saw
head forward/backward movement until the saw head
stops. Failure to do so may result in serious sawmill dam-
age.
WARNING!
When using the variable reverse speed wiring
it is recommended that the operator should stop the head,
turn the potentiometer to zero, engage reverse and then
increase speed. Failure to do this may result in damage to
the circuit. There is a protection in the circuit and if this is
activated it will not allow the head to start the return move-
ment until the potentiometer is set to zero.
!
