Sawmill Alignment
Routine Alignment Procedure:
Sawmill Alignment
HDSdoc021716
5-6
5
See Figure 5-5.
Loosen the horizontal adjustment bolt jam nuts. To tilt the arm in toward the blade, loosen
the right bolt and tighten the left bolt. To tilt the arm out away from the blade, loosen the left bolt and tighten
the right bolt. Retighten the jam nuts and recheck the blade guide arm horizontal tilt.
5.
Now check the vertical tilt of the blade guide arm. Move the saw carriage so the blade guide arm is
positioned over a bed rail.
6.
With the arm 1/2" (15 mm) from fully closed, raise or lower the saw head until the bottom of the blade guide
block is 15" (375 mm) from the top of the bed rail.
FIG. 5-5
Right Horizontal Adjustment Bolt
Left Horizontal Adjustment Bolt