Sawmill Alignment
Complete Alignment Procedure
Sawmill Alignment
HDSdoc021716
5-26
5
blade. Adjust the inner blade guide assembly so the roller flange is 1/16" from the blade.
See Figure 5-23.
Tighten the two previously-loosened tilt adjustment screws to secure the blade guide assembly. Turn the top
adjustment bolt clockwise to raise the blade guide assembly so it does not touch the blade.
NOTE:
Before adjusting the top bolt, unload pressure on the bolt by turning
1/2 turn in the opposite direction it was last adjusted.
With the roller flange positioned properly from the back of the blade, adjust the rear bolt so it touches the end
of the blade guide mounting shaft.
FIG. 5-23
Turn bolt clockwise
to raise assembly so
roller does not touch
the blade
600122-16B
Tighten tilt screws to
secure blade guide assembly
Adjust rear bolt to
touch blade guide
shaft