Setup & Operation
Middle track cover
Setup & Operation
HDSdoc021716
2-11
2
6.
Level the sawmill by adjusting the outriggers to raise or lower each end of the sawmill. Adjust all outriggers
evenly to avoid twisting the mill frame by jacking one outrigger higher than the others.
Raise the side supports to prevent the log from falling off the side of the mill when loaded.
See Figure 2-4.
2.4
Middle track cover
Before operating the sawmill do as follows:
1.
Clean the upper and lower rails to remove any sawdust and rust preventives.
2.
Unbolt and remove the middle track cover from its storage position.
3.
Soak the felt wiper with Dexron III transmission fluid, 10W30 motor oil or 3-in-1 turbine oil.
4.
Install the middle track cover so it fits against the rail and secure with two thumb screws.
FIG. 2-4
Side
Support
Bed Rail
Stop Block
