Setup & Operation
Preparing The Sawmill For Transportation
2
2-36
HDSdoc021716
Setup & Operation
See Figure 2-16.
CAUTION!
It is important that the lower stop bolts are properly adjusted to
secure the carriage on the track rail. Failure to properly adjust the stop bolts
can cause saw head damage, especially during mill transportation.
6.
If necessary, adjust the two stops located at the bottom of the mast so the saw head contacts them after it is
lowered 3/4" (19mm) past where it contacts the rest pin.
See Figure 2-17.
7.
Use the hydraulic controls to raise the log turner and loader as high as they will go. Manually lift the loader
FIG. 2-16
FIG. 2-17
Rest Pin
Loosen jam nut
and turn bolt
to raise or lower
stop bolt
