15
template for both cutters and fences.
Also note on the board which skims
and blades you used.
2 / You can experiment with adjusting
the pressure on the feed rollers. Note
the default setting before you start so
you can come back. Normally, springs
are clamped tighter on the right side
especially on narrow board planed.
The feed rollers force should be
balanced so it will not press to much
on one side.
Maintenance
PH360 is easy to maintain 95% of the
machine is rust resistant.
Cutterbrarings and motors are
maintenance free. The maintenance
required to be mentioned below. Make
sure the machine is not power
connected before any maintenance.
After each session:
-Clean the machine from the chips.
-Clean the table from the resin. Apply
table with paraffin oil.
Maintenance at regular intervals
the following:
-Lubricate the following parts with oil
on a regular basis:
* The feed rollers bearings.
* Elevator spindles and its upper and
lower bearings.
* The chain thats adjust the table
height.
* The chain for driving the feed rollers.
* The two slide ways of the variable left
vertical cutter, and its spindle.
Check that all screws and bolts are
tight and that the cables
and electrical connections are in good
condition.
If the machine must be stored in a
damp environment for a long time, all
non-stainless parts are treated against
corrosion. Cover the machine.
Use transmission oil and on the table
paraffin oil.
Summary of Contents for PH365
