17
Table setting
Basics
It is a serious intervention in the
machine to reset the table. Make sure
that it's really needed. The machine is
factory set but may have changed their
by careless transport or high shock
loads.
Adjusting the over cutter to the
table
2 / Remove the screws on the bearing
bracket (4 M8 on each side)
3 / Place an absolutely flat block on
the table in the middle of the cutter.
4 / Crank the table so that the cutter is
lifted slightly
5 / Lock bolts to the frame
Adjusting the table to the cutter
for example, the chain is loose or too
little adjustment range is left for the
cutter.
1 / Place an absolutely flat block on
the table in the middle of the cutter.
2 / Crank flat table so that the block
touches the cutter
3 / Remove the chain to the table.
4 / Turn up every spindle so that the
cutter touches the block for its entire
length.
5 / Check the dimension on the front
and back of the table to the stand to
adjust the front or rear pair of lift
spindles
6/Assemble the chain to the the table.
Make sure that each spindle can be
rotated by hand.
Summary of Contents for PH365
