Wood’s LD24, Operating Instructions Manual

07

EN

INSTRUCTIONS FOR USE

TECHNICAL DATA

LD24

LD40PRO

Max working area

80 m

2

180 m

2

Air flow step 1

200 m

3

/h

300 m

3

/h

Dehumidifying at 20˚C and 70% r.h.

6,5 L/24h

16 L/24h

Dehumidifying at 30˚C and 80% r.h.

12 L/24h

31 L/24h

Power at 20˚C and 70% r.h.

160 W

450 W

Energy consumption at 20˚C och 70% r.h.

4,3 kWh/24 h

9,1 kWh/24 h

Tank volume

11,4 liters

11,4 liters

Refrigerant

R290

R290

Refrigerant change

99 g

130 g

Voltage

230 V

230 V

Frequency

50 Hz

50 Hz

Fuse

10 A

10 A

IP-class

X1

X1

Dimensions (L x W x H)

400 x 345 x 580 mm

400 x 345 x 580 mm

*Technical changes and improvements may occur. All values are approximate and may vary depending on external circumstances such as 

temperature, ventilation and humidity.

PROBLEM

REMEDY

The dehumidifier does not start

•  Make sure that the dehumidifier is connected to the socket and that the fuse has not blown.
•  If the indicator light is red, check that the water tank is empty and correctly positioned in the dehumidifier. Ensure the 

float hangs freely.

•  Check that the hygrostat works by turning it up to max. The dehumidifier should then start within 5 min. 

The dehumidifier does not start

•  Make sure the fan wheel is spinning.
•  Make sure that the air can flow freely through the dehumidifier. Air emissions and air filters must be clean and the 

dehumidifier must be at least 20-30 cm from the wall.

•  Listen if the compressor is running, but keep in mind that the dehumidifier may be defrosting cycle and then the 

compressor will stop. Start by waiting for about 30 minutes.

•  Check that a thick layer of ice does not form on the cooling coils / slats behind the filter.

High noise level/rattling 

•  Increase the distance between the dehumidifier and surrounding surfaces.
•  The cooling coils may make contact to each other and cause vibrations. Disconnect the dehumidifier from the electrical 

outlet and separate the loops

No condensate water collected 

•  Check that no dirt etc. is deposited on the drip tray underneath the cooling coils, clean if necessary.
•  Check that the temperature is above 2 ° C or below 35 ° C.

Does not shut off when water tank is full. 

•  It is important that the float hangs freely in the water tank. If it does not, it does not sense the water level is and can 

therefore not ensure that the dehumidifier stops

If you have a problem with your dehumidifier, refer the troubleshooting guide. If none of the above works, contact your dealer to get your 

dehumidifier serviced.