GB
9
Operating Instructions
05
OPERATION
1. Plug into power socket and then press
the “ON/OFF” button to turn on the
unit. The machine start up automatically
and the unit is in the status of constant
dehumidifying.
2. Press the “HUMIDITY” to set desired
humidity 40%»50%»60%»CO .
CO indicates as continuous
dehumidifying, which unit will keeps
dehumidifying without affected by
ambient humidity.
The compressor will stop automatically
when reached humidity setting.
Note: Once humidity reaches target
setting, both compressor and fan will
stops operating for an hour. An hour
later, fan will operates 3 minutes for
air circulation. If ambient humidity is
higher than target setting, unit will starts
dehumidifying.
If ambient humidity is lower than target
setting, compressor and fan will stops
another one hour.
3. Press “TIMER” to set the working hour of
units 2h»4h»8h»No timer.
4. Press the ““ON/OFF” button to turn on
the unit.”
WATER FULL
When the water container is full, an alarm
signal will be produced.- the compressor
will stop automatically, this will also stop
the dehumidification process.
Empty the water container and replace it
in the correct position, the dehumidifier
will continue dehumidifying when the
compressor, automatically, starts after
five minutes. (See compressor protection
function)
COMPRESSOR PROTECTION
FUNCTION
The unit is equipped with compressor
protection function—that is, compressor
has five minutes period between starts
operation and shut down.
WATER DRAINAGE
If desired, it possible to connect the
drainage tube (Optional) to the device
for permanent water drainage. Simply
connect a drainage hose to the drain
spout and ensure that the end of the
hose is lower than the drain opening,
otherwise the water will not drain and
flooding may occur.
DEFROSTING
When the machine is in the environment
of low temperature during operation, the
surface of the evaporator may frost, in
order to ensure the normal operation of
the machine, machine is provided with an
automatic defrosting function.
MEMORIZE FUNCTION
Unit will memorize previous setting when
power plug is connected.
Unit will operates in default setting
when unit is turned off and power plug is
disconnected.
AUTOMATIC RESTART AFTER POWER
FAILURE
Unit will automatically turn on and
operates in last setting after power
returns.
MAINTENCANCE AND CLEANING
For its casing is made of plastic, do not
place it in direct sunlight.
Remove the water tank with care.
If not using the unit for a long time. Please
Switch off and unplug the unit, empty
the water reservoir, keep it in dry and
ventilated place.Only use a soft clean
cloth for all cleaning purpose. Do not use
gasoline, paint thinner or other chemicals
to clean the unit.
Cleaning mesh filter: Remove the filter use
a vacuum cleaner or water to clean, then
put it in ventilated place until it’s dry.
Summary of Contents for MDK11
Page 88: ......
